The CD4050 hex buffers are monolithic complementary MOS (CMOS) integrated circuits constructed with N- and P-channel enhancement mode transistors. These devices feature logic level conversion using only one supply voltage (VDD). The input signal high level (VIH) can exceed the VDD supply voltage when these devices are used for logic level conversions. These devices are intended for use as hex buffers, CMOS to DTL/ TTL converters, or as CMOS current drivers, and at VDD = 5.0V, they can drive directly two DTL/TTL loads over the full operating temperature range.

• High Speed Binary Ripple Carry Counter
• Separate Reset Input Pin
• Wide Operating Voltage Range: 2.0 to 6.0 V
• Output Drive up to 10 LS-TTL Loads
• Equivalent to CD4060

The MC34063A Series is a monolithic control circuit containing the primary functions required for dc-to-dc converters. These Buck Boost Inverting Switching Regulators consist of an internal temperature compensated reference, comparator, controlled duty cycle oscillator with an active current limit circuit, driver and high current output switch. Operation from 3.0 V to 40 V Input. Output Switch Current to 1.5 A.

This is a monostable multivibrator or pulse generator.

The CD4024 is a 7-stage ripple-carry binary counter. Buffered outputs are externally available from stages 1 through 7. The counter is reset to its logical 0 stage by a logical 1 on the reset input. The counter is advanced one count on the negative transition of each clock pulse.

• Dual inputQuad NAND gate operation.
• Input voltage range: -0.5 to VDD +5V
• Power dissipation of 100mW per logic change.
• It is available in different outline packages
• The propagation delay time is 60ns
• All input and output pins are buffered for high throughput
• The output characteristics are standardized symmetric
• CD4011 draws a maximum input current of 1 Ampere at 18 volts
• Offers different noise margin level according to the input voltage level
• Temperature operating range is -55C to +125C

• Low-voltage and Standard-voltage Operation
  • 2.7 (VCC = 2.7V to 5.5V)
  • 1.8 (VCC = 1.8V to 5.5V)
• Internally Organized 128 x 8 (1K), 256 x 8 (2K), 512 x 8 (4K),
• 1024 x 8 (8K) or 2048 x 8 (16K)
• Two-wire Serial Interface
• Schmitt Trigger, Filtered Inputs for Noise Suppression
• Bidirectional Data Transfer Protocol
• 100 kHz (1.8V) and 400 kHz (2.7V, 5V) Compatibility
• Write Protect Pin for Hardware Data Protection
• 8-byte Page (1K, 2K), 16-byte Page (4K, 8K, 16K) Write Modes
• Partial Page Writes Allowed
• Self-timed Write Cycle (5 ms max)
• High-reliability
  • Endurance: 1 Million Write Cycles
  • Data Retention: 100 Years
• Automotive Devices Available
• 8-lead JEDEC PDIP, 8-lead JEDEC SOIC, 8-lead Ultra Thin Mini-MAP (MLP 2×3), 5-lead SOT23, 8-lead TSSOP and 8-ball dBGA2 Packages
• Die Sales: Wafer Form, Waffle Pack and Bumped Wafers

• A dual version of NE556 consists of two precision timers that operate in both monostable and astable modes.
• It is specified for operation from 4.5 V to 16 V.
• TTL compatible output which can source or sink current of up to 150mA.
• Adjustable duty cycle.
• It can produce a timing delay from microseconds to hours.
• The operating temperature range is from 0 to 70 degrees Celsius.
• It has temperature stability better than 0.005% per C.