Programmers

  • You've just added this product to the cart:

    EPROM 27C16

    0 out of 5

    EPROM 27C16

    EPROM 27C16 is a high speed 16K UV erasable and electrically reprogrammable CMOS EPROM ideally suited for applications where fast turnaround pattern experimentation and low power consumption are important requirements The 27C16 is packaged a 24-pin dual-in-line package.Access time down 450 ns Low CMOS power consumption Active Power 25 mW max Standby Power 53 mW max (98% savings) Performance compatible to NSC800TM CMOS microprocessor Single 5V power supply Pin compatible to MM2716 and higher density EPROMs Static no clocks required TTL compatible inputs outputs TRI-STATE output Windowed DIP Package Specifications guaranteed over full military temperature range 125 C).

  • You've just added this product to the cart:

    M24C08

    0 out of 5

    M24C08

    The M24C08 is an 8-Kbit I2C-compatible EEPROM (Electrically Erasable PROgrammable Memory) organized as 1 K × 8 bits. It operate with a clock frequency of 400 kHz.

  • You've just added this product to the cart:

    Serial EEPROM AT24C02

    0 out of 5

    Serial EEPROM AT24C02

    AT24C02 is an electrically erasable and programmable ROM. It has a 2Kbits of memory size arranged in 32 pages of 8 byte each. There are 256 (32 x 8) words each of one byte. The data is transferred and received serially through serial data (SDA) pin.

  • You've just added this product to the cart:

    USBtinyISP-Arduino bootloader programmer

    USBtinyISP-Arduino bootloader programmer
    0 out of 5

    USBtinyISP-Arduino bootloader programmer

    INTRODUCTION

    This is a USB AVR programmer supported by offical Arduino IDE. Once the Arduino has lost its bootloader for some reasons, use this programmer to reburn the bootloader and save the dead Arduino.

    This programmer works really well for ATmega168 and ATmega328 and should work with all the AVR micros supported by AVRDUDE.  Both 10-pin and 6-pin targets supported (cable included) which makes the progrmmer suitable for most AVR boards.

    This programmer is based on  USBtiny code & design Version 2.0

    The Kit comes with both 6-pin and 10-pin AVR-standard connectors and cables.

    Product Update Log

    • 2011/08/23 : The  Verion 1 has  identified that 10 PIN IDC has incorrect MISO and  MOSI Pin out.    It will be fixed in version V1.1 
    • V3 hardware revision has a board layout update increasing usability. Compatible with older versions.
    1,500.00