• Wide range of digital and analog signal levels: digital 3 – 15V, analog to 15Vp-p
• Low “ON” resistance: 80Ω (typ.) over entire 15Vp-p
  • signal-input range for VDD − VEE = 15V
• High “OFF” resistance:
  • channel leakage of ±10 pA (typ.) at VDD − VEE = 10V
• Logic level conversion for digital addressing signals of
  • 3 – 15V (VDD − VSS = 3 – 15V) to switch analog signals
  • to 15 Vp-p (VDD − VEE = 15V)
• Binary address decoding on chip

TC 4427 is a dual high speed power mosfet driver. ThIS device IS highly latch-up resistant under any conditions within their power and voltage ratings. All terminals are fully protected against Electrostatic Discharge (ESD).

The 7408 is a QUAD 2-Input AND gates and contains four independent gates each of which performs the logic AND function. It comes in 14-pin DIP package. 7408 AND Gate IC 74HC244 74244 Octal Buffers & Line Driver IC in Pakistan

The CD4040 is a 12-stage ripple carry binary counter. The counters are advanced one count on the negative transition of each clock pulse. The counters are reset to the zero state by a logical 1 at the reset input independent of the clock.

The 4072 is a member of the 4000 Series CMOS range, and contains two independent OR gates, each with four inputs.

This is a monostable multivibrator or pulse generator.

The SN74HC244N is an Octal Buffer and Line Driver IC, designed specifically to improve both the performance and density of 3-state memory address drivers, clock drivers and bus-oriented receivers and transmitters. This device organized as two 4-bit buffers/drivers with separate output-enable (OE)/inputs. When OE/ is low, the device passes non-inverted data from the A inputs to the Y outputs. When OE/ is high, the outputs are in the high-impedance state.

Texas Instruments SN7414 Series Inverters are available at ElectroNation.

The 74LS139 is a high speed Dual 1-of-4 Decoder/De-multiplexer. The device has two independent decoders, each accepting two inputs and providing four mutually exclusive active LOW Outputs. Each decoder has an active LOW Enable input which can be used as a data input for a 4-output demultiplexer. Each half of the LS139 can be used as a function generator providing all four minterms of two variables. The LS139 is fabricated with the Schottky barrier diode process for high speed and is completely compatible with all Motorola TTL families.

This IC is a 16-Bit SPI I/O Expander with Serial Interface. This IC has 25mA sink/source capability per I/O.

The 4N25 is an optocoupler for general purpose applications. It contains a light emitting diode optically coupled to a photo-transistor.

It is an integrated circuit that converts the signals from the RS232 serial port to the proper signal which is used in the TTL compatible digital logic circuits. The MAX232 can convert the signals like RX, TX, CTS, and RTS and it is a dual driver/receiver.

The Exclusive OR gates are monolithic complementary MOS (CMOS) integrated circuits constructed with N-Channel and P-Channel enhancement mode transistors. All inputs are protected against static discharge with diodes to VDD and VSS.

This device is designed for use where the output voltage is a product of an input voltage (signal) and a switching function (carrier). Typical applications include suppressed carrier and amplitude modulation, synchronous detection, FM detection, phase detection, and chopper applications.

ULN2004 Features

• Output current (single output): 500mA (MAX.)
• High sustaining voltage output: 50V (MIN.)
• Output clamp diodes
• Inputs compatible with various types of logic

• Compatible with MCS-51 Products
• 4K Bytes of In-System Reprogrammable Flash Memory
• Endurance: 1,000 Write/Erase Cycles
• Fully Static Operation: 0 Hz to 24 MHz
• Three-Level Program Memory Lock
• 128 x 8-Bit Internal RAM
• 32 Programmable I/O Lines
• Two 16-Bit Timer/Counters
• Six Interrupt Sources
• Programmable Serial Channel
• Low Power Idle and Power Down Modes