Accelero, Gyro. IMU, Magneto

Show
  • Out Of Stock

    3 Axis Accelerometer + 3 Axis Gyroscope + 3 Axis Magnetometer + Pressure Sensor on one board i.e.

    ADXL 345+L3G4200D+HMC5883L+BMP085 sensors all in one board. There are also a 2.5V voltage regulator, the logic level converter circuit to make it work under the power of 3V-5V. Thanks to the logic level converter circuit, you can connect it with a 3V-5V MCU directly, just plug and play! Also every interrupt pin of the sensors is leaded out.

  • Out Of Stock

    INTRODUCTION

    This is an infrared distance switch. It has an adjustable detection range, 3cm – 80cm. It is small, easy to use, assemble, and inexpensive. Useful for robotics, interactive media, industrial assembly line, etc. Infrared wave length is part of the Sun’s natural light spectrum. While is a nice fit for indoor projects, outdoors with plenty of sun light and reflective surfaces on it’s sight is not adviced. It’s incredibly repurposable and can be used for a lot of different projects. The adjustable screw on it’s back makes it very convenient for different purposes. Digital read on your Arduino pin and you are ready to go. Good sensor choice for quick prototyping.

    Use it on a robot for wall detection and wall follower, or as some of the projects listed below as a trigger system. It’s round shape with the screwable holders make it a good choice for a home made assembled robot, with a hole of it’s diameter and the holders you can place it aiming at different positions on a robot. Or even place it near your PC to turn on and off your monitor.

  • -20%

    GY-273 HMC5883L Triple-axis Magnetometer Compass Module

    (0)
    Original price was: ₨750.00.Current price is: ₨599.00. Quick View
    1. Type: GY-271
    2. Operating Voltage : 3 -5 V DC.
    3. Chipset: HMC5883L.
    4. Communication: I2C protocol.
    5. Measuring range: ± 1.3-8 Gauss.
    6. Dimensions : 14.8 x 13.5 x 3.5 mm.
    7. Weight: 2 gm.
    8. 3-axis magnetic electronic compass.
    9. Precise heading information.
    10. Fits into small projects easily.
    11. I2C communication.
  • -20%

    GY-273 Magneto HMC5883L

    (0)
    Original price was: ₨750.00.Current price is: ₨599.00. Quick View
    1. Supply Voltage VCC: 3.3 to 6 V
    2. Heading Accuracy: 1 to 2
    3. Magnetic Field Range: -8 to +8 Gauss
    4. I2C Address: 0x1E (7-bit address)
    5. Max Data Rate: 160 Hz
    6. Digital Voltage Level: 3.3V
    7. Dimensions (excluding pins): 18.2mm (0.717) x 13.3mm (0.524) x 2.2mm (0.087)
    8. Weight: 0.95g (0.034oz)
  • -41%

    GY-291 ADXL345 3-Axis Accelerometer Module

    (0)
    Original price was: ₨590.00.Current price is: ₨349.00. Quick View
    • Main Chip: ADXL345
    • Model: GY-291
    • Power Supply: 3-5V
    • Means of Communication: IIC / SPI Communication Protocol
    • Measuring Range: ±2g /±16g
    • Digital-Output Triple-Axis Accelerometer with a Programmable Full-Scale Range of ±2g, ±4g, ±8g and ±16g and Integrated 16-bit ADCs
    • Accelerometer Normal Operating Current: 450µA
    • Ultralow Power: as low as 23 μA in Measurement Mode and 0.1 μA in Standby Mode at VS = 2.5 V (typical)
    • Sleep Mode Current: 8µA
    • Communication: SPI (3- and 4-wire) and I2C Digital Interfaces
    • User-Programmable Interrupts
    • Wake-On-Motion Interrupt for Low Power Operation of Applications Processor
  • -12%

    Gy-61 Triple Axis Accelerometer Adxl335

    (1)
    Original price was: ₨1,990.00.Current price is: ₨1,749.00. Quick View
    1. 3V-6V DC Supply Voltage
    2. Onboard LDO Voltage regulator
    3. Can be interfaced with a 3V3 or 5V Microcontroller.
    4. All necessary components are populated.
    5. Ultra Low Power: 40uA in measurement mode, 0.1uA in standby@ 2.5V
    6. Tap/Double Tap Detection
    7. Free-Fall Detection
    8. Analog output
    9. Build in ultra-low noise linear LDO voltage regulator
    10. Built-in onboard filters, which reduce noise from the motor and other high-current electronics
    11. All sensors connected to the I2C bus
    12. You can easily select two I2C addresses for MPU6050 by soldered jumper
    13. Power LED
    14. Build in Logic level converter for I2C
    15. Dimensions 20x16mm
    16. Designed for 5V logic level
  • -19%

    GY521 MPU6050 3 Axis Digital Gyroscope Accelerometer Sensor Module

    (0)
    Original price was: ₨490.00.Current price is: ₨399.00. Quick View

    3-axis gyroscope and a 3-axis accelerometer are combined together on the same silicon die with an onboard Digital Motion Processor. Easy to get it fit into your project! It is very accurate, as GY-521 Mpu6050 Module contains 16-bits analog to digital conversion hardware for each channel. Therefor Three axis Gyrometer captures the x, y, and z channel at the same time. The sensor uses the I2C-bus to interface with the Arduino.

  • -27%

    GY521 MPU6050 Module 6DOF

    (1)
    Original price was: ₨550.00.Current price is: ₨399.00. Quick View
    • Chip: MPU-6050
    • Power supply: 3v-5V
    • Gyroscope range: + 250 500 1000 2000/ s
    • Acceleration range:  2  4  8  16 g
    • Communication: Standard IIC communication agreement
    • Chip built-in 16 bit AD converter, 16 bits of data output
    • Pin Pitch 2.54 mm
    • SIZE: 20.3mm x 15.6mm
  • -12%

    Hall Sensor 44E

    (0)
    Original price was: ₨180.00.Current price is: ₨159.00. Quick View
    1. 3.5V to 24V DC operation voltage
    2. Low current consumption
    3. Temperature compensation
    4. Wide operating voltage range
    5. Open-Collector pre-driver
    6. 50mA maximum sinking output current
    7. Reverse polarity protection
  • -18%

    MPU9250 IMU 9DOF MPU-9250

    (0)
    Original price was: ₨2,000.00.Current price is: ₨1,650.00. Quick View
    • Three 16-bit analog-to-digital converters (ADCs) for digitizing the gyroscope outputs
    • Three 16-bit ADCs for digitizing the accelerometer outputs
    • Three 16-bit ADCs for digitizing the magnetometer outputs
    • Gyroscope full-scale range of 250, 500, 1000, and 2000/sec (dps)
    • Accelerometer full-scale range of 2g, 4g, 8g, and 16g
    • Magnetometer full-scale range of 4800T
    • I2C and SPI serial interfaces
    • Internal Digital Motion Processing engine supports advanced MotionProcessing and low power functions such as gesture recognition using programmable interrupts
    • Power supply: 3-5v
  • -26%

    RPM Measurement Sensor Rotational Speed Measuring Module

    (0)
    Original price was: ₨160.00.Current price is: ₨119.00. Quick View
    • Input voltage: 3.3V to 5V
    • Output signal: TTL signal, active low
    • Pulse frequency range: 0 to 100Hz
    • RPM range: 0 to 6000RPM
    • Dimensions: 32 x 14 x 7mm
    • Weight: 5g