MONSTER MOTO SHIELD DUAL VNH2SP30 16V 30A

MONSTER MOTO SHIELD DUAL VNH2SP30 16V 30A The L298 H-bridge is no longer available in the Motor Driver Shield Monster Moto since it has been replaced with a pair of VNH2SP30 full-bridge motor drivers. The Motor Driver Shield Monster Moto has been enhanced to drive a pair of high-current motors while the VIN and motor have been adjusted for connecting larger wires more easily.

NOTE: If you use this shield for high-demand applications it is recommended to use a heat sink or a fan and to solder the wires directly to the board rather than connecting them with a screw terminal.

• Power supply: Max 16V
• Max current rating: 16A
• Practical Continuous Current: 14A
• Current sensing available to Arduino analog pin
• MOSFET on-resistance: 19 m OHM (per leg)
• Maximum PWM frequency: 20kHz
• Thermal Shutdown
• Under-voltage and Over-voltage shutdown.