Motor Drivers

Default sorting
Show
48
  • -23%

    A4988 Stepper driver

    Motor Drivers
    Original price was: ₨350.00.Current price is: ₨269.00. Quick View
    1. Supply Voltage : 8-35 VDC.
    2. Current : 1.0A (no heatsink ).
    3. Current : 2.0A (with heat-sinking).
    4. logic input : 3 – 5.5V .
    5. Automatic current decay mode detection/choice.
    6. Mixed with slow current decay mode.
    7. The low power dissipation of synchronous rectifier.
    8. Internal UVLO(ultra voltage lockout).
    9. Crossover current protection.
    10. Thermal shutdown circuit.
    11. Ground fault protection.
    12. Loading and short circuit protection.
    13. The optional five-step mode: full, 1/2, 1/4, 1/8 and 1/16.
  • -6%

    BTS 7960 Motor Driver 43A

    Motor Drivers
    Original price was: ₨1,800.00.Current price is: ₨1,699.00. Quick View
    • Double BTS7960 large current (43 A) H bridge driver;
    • 5V isolate with MCU, and effectively protect MCU;
    • 5V power indicator on board;
    • voltage indication of motor driver output end;
    • can solder heat sink;
    • Just need four lines from MCU to driver module (GND. 5V. PWM1. PWM2);
    • isolation chip 5 V power supply (can share with MCU 5 V);
    • size: 4 * 5 * 1.2 cm;
  • -15%

    L298-Mini

    Motor Drivers
    Original price was: ₨350.00.Current price is: ₨299.00. Quick View

    1.Module supply voltage: DC 2V-10V
    2.Signal input voltage: DC 1.8-7V
    3.Single working current: 1.5A
    4.Peak current up to 2.5A
    5.Low standby current (less than 0.1uA)
    6.Built-in common conduction circuit, the input terminal vacant, the motor does not malfunction
    7.Size: 24.7 x 21 x 7mm
    8.Mounting hole diameter: 2 mm

  • -3%

    MONSTER MOTO SHIELD DUAL VNH2SP30 16V 30A

    Motor Drivers
    Original price was: ₨1,300.00.Current price is: ₨1,259.00. Quick View
    • Power supply: Max 16V
    • Max current rating: 16A
    • Practical Continuous Current: 14A
    • Current sensing available to Arduino analog pin
    • MOSFET on-resistance: 19 m OHM (per leg)
    • Maximum PWM frequency: 20kHz
    • Thermal Shutdown
    • Under-voltage and Over-voltage shutdown.
  • -6%

    TB6600 Arduino Stepper Motor Driver 4A, 5A

    Motor Drivers
    Original price was: ₨1,800.00.Current price is: ₨1,699.00. Quick View
    • This stepper motor driver supports 8 kinds of current control.
    • This stepper driver supports 7 kinds of micro-steps adjustable.
    • Stepper motor driver interface adopts high-speed optocoupler isolation.
    • It has the feature of automatic semi-flow to reduce heat.
    • It has a large area heat sink.
    • It has anti-high-frequency interference ability.
    • It has input anti-reverse protection
    • It has the feature of overheating, over-current, and short circuit protection.
  • Out Of Stock

    ULN2003 Stepper Driver 5V

    Motor Drivers
    ₨149.00 Quick View

    This is ULN2003 Driver Module Stepper Motor Driver, small size and easy to use. It uses the ULN2003 driver chip to amplify the control signal from the Arduino. This Ultra Lightweight and cheap option commonly used to run and control the small applications stepper motors.